It is easier to connect your camcorder through the included "PowerCinema NE for Everio". First (since you're running Vista), you have to download a patch. Here is the address:
http://www2.cli.co.jp/products/ne/update_everioM7SD/pcm4e_update.htm
Note: Only after you have installed PowerCinema NE for Everio can you install the patch. After you have installed the patch, just connect your MG130 to your computer through the included USB cable. Then the software should run automatically.
Hope this Helps
Eric
I connect my JVC gz-mg26 to my PC running Vista Ultimate and the camera displays "usb mass storage"indicating it is connected to the PC, but the PC does not recognise the camera in "my computer".
I have searched for a few hours to find a suitable driver for this, but have had no luck so far - not even on the JVC website. This is not good enough..
If anyone can help, please reply.
×