- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
find a mobility scooter supplier in the yellow pages /on line and get one from there
check but most chargers are generic for the voltage of the scooter
it could be the free leaver is slipping on or dose the scooter look lopsided from the back if it is could be the axle i had that problem with mine stopped and started and was the axle an expensive repair but was worth it,or battries could be done,
what city and state do you reside in ... i am a servicer in the dallas ,ft.worth texas area would be glad to make a service call to your residence if you are with travel distance...
toll free 1-877-523-2101 monday -friday 9am to 5 pm thanks
have yoy checked that the battery is well pluged. meaning possitive with possitive and negative with negative. sometimes grasse is stock on the joints of electricity, so brush them with a metalic brush, that should solve the proble.
I have repaired a scooter with the same problem, it normally the rear part of the motor connections, like string loaded connectors, you will need to gently rough up the connecters so a good connection is made , also below the bike there are the main wiring connecters again remove the connectors then reinsert, this is normally a bad connection problem. where the read disconnects to the main scooter is the main area of connection problems.
i think some radio shacks help out with that stuff, and you can always look online for local repair shops. i actually have a lens problem myself. good luck
It is time to replace the batteries. Buy two, not just one. This scooter takes two 12 volt, 12 amp hour, sealed deep cycle batteries. If you replace just one, the charger will not charge them properly.
Take off the seat (pull upward). Turn the scooter on its side. Remove the six screws (2 in front, 2 under the foot rest, and 2 in the back. Unsnap the old batteries (one at a time) and replace with new. Be sure to keep the wiring as is, so you keep the circuit in series (not in parellel). In fact, before you remove the old batteries, label the connections (A to A, B to B, etc.) so you reconnect just as they were. Total cost is about $200. Time to replace is about a half hour.
×