Between the fuses, resistors, and the IC packs I think you've done well. Your going to have to recheck your soldering on those lands at the IC's pins, or replace the defective (new) packs.
Thanks dburns. I was leaning towards the ICs too. I checked the solder again and ckd continuity of the pads to next-in-line components and they all check good (even with an eye loupe, these eyes and mind are getting old). Someone local suggested i check the other resistors (non-3,9ohms) on the off chance one of them may have taken a hit. Other well meaning techs have been pointing to Service Menu items, but the R
×
155 views
Usually answered in minutes!
×