Dryer wont tumble when loaded.

recheck the belt, Tim:

http://forum.appliancepartspros.com/dryer-repair/25860-dryer-belt-diagrams.html

these are the items/parts:

1) belt may be stretched, examine belt for cracking and if it looking old replace
2) idler arm/pulley may be wore out, examine
3) drum rollers/glides may be wore out (second link)
4) motor may be going out

for the belt,idler arm/pulley and motor:

http://www.partselect.com/dryer+dryer-wont-tumble+repair.htm

drum roller/glides:

http://www.partselect.com/dryer+dryer-tears-clothes+repair.htm

The drum in the dryer has most likely has a belt around it that makes it turn. This belt could have broken and you hear the motor running but the drum can't turn. For more info look it up on you tube. (dryer belt replacement)

Your belt may be slipping and not spinning the drum to full speed to rid most of the water in clothes.

How to Replace A White Knight Tumble Dryer Heating Element Heater and Thermostat

For a full list of appliance Video Repair help see our video section
White knight tumble dryer not heating this video show you how to change and fit a new heating element and thermostats can be used on Ariston, Electrolux, Ignis, Neutral, Tricity Bendix, Whirlpool,
Here is the element in this video
For all you tumble dryer spare parts click here

The easiest way to find you part is put your model number into our search bar at http://www.apart4u.co.uk/ TEL 08455218000
http://www.apart4u.co.uk/news/category/questions-and-answers/diagrams/

Probably is the belt

Your belt is not installed correctly. The weight of the clothes is making it slip.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

Did it get tipped in the move? I don't know about the specific model of Maytag, but on my old Kenmore the belt that ran the drum also had a wheel and kind of like a pulley that it had to seated on in order for the belt to stay centered on the drum and turn properly.I don't know how you get the shell off the front to get at the drum, the Kenmore had screws that you had to take out and lift the control panel off and then back to get at the inside. Sorry

call someone in to fix it...it will be easier and the belt can be a pain to put on again.

Does the Motor turn... We have had many motors with bad capacitors .. check the white capacitors for cracks or metal coming out of it...the motors will run with out a load on the but put a few clothes in the drum and they will just hummm..