Set clock on kdc-mp208 - Kenwood KDC-MP208 Car CD/ MP3 Player

1:- Select Clock Adjustment mode Press the top or bottom side of the Control knob. Select the "ClK ADJ"/ "ClCK" display. 2:- Enter Clock Adjust mode. Press the centre of the Control knob for at least 1 second. The clock display blinks. 3:- Adjust the hours. Press the top or bottom side of the Control knob. Adjust the minutes Press the right or left side of the Control knob. 4:- Exit Clock adjustment mode, Press the [B.BOOST] button.
Now whats the time, Gotta get my tea.
Regards, Dave

See page 11: http://www.kenwoodusa.com/UserFiles/File/Global/Consumer/Manuals/kdcmp238.pdf

there should be a button labeled menu. press this button for a few seconds and it should take you into menu mode. use the fm/am buttons to scroll through the menu until ;you reach clock, the press the seek up or down button until the display starts flashing. use the am/fm and seek buttons to set the hour and minutes. press the menu button again to leave the menu.

how i do set up the clock mutimidia radio mp4

On the remote wire of the stereo always be a blue one

Make sure that the source is set to "Standby" when trying to access the menu. It took me about an hour to figure it out and afterward I felt like a ******.

This is usually ground problem. check ground wire

Try pressing down on the directional pad located on the right side of the stereo, this should bring you to the AM setting. If that doesn't work, make sure you have the proper antenna cable installed as well as the proper wiring harness.

First, set the clock if it isn't already set. You need to get your cd player into standby mode and then hold the "boost" button. This should get you into a menu. Use the up and down pad to scroll through the options until you find "clock" hold the center button to get into the mode, to set the clock. Once in use the up and down, left and right pad to set the time. Then press the menu button to get out. Press the source button to get back into a normal mode, then hold that "boost" button again. This should bring you into a different menu. scroll through the menu until you see "display" and you should be able to choose to display clock in there. I hope I didn't steer you wrong. Let me know if you need further help. Good luck
-Andrew Hawkins