Planar PCI device does not respond or disbale by user

Ok, That' s a motherboard issue. You would have to replace motherboard...

Workaround:
1: Set server in minimum configuration(single processor and two RAMs)
2: Remove any PCI cards added in server
3: Turn on server check for issue
If plannar fault appear, you have to replace motherboard..

Thanks

I have a problem with x346 server i need raid drivers for windows server 2008 32 bit please if some one can help/

Hi,

Welcome to fix ya

Yes you can monitor the raid controller by using IBM RAID MANAGER softwfare. Hope you are having windows platform . Click the below link and download the software.

http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-61707

please download the file named ibm_sw_srapp_9.20-16999_anyos_32-64.iso . After download burn it into cd . Now insert the cd and install the raid manager software.

Thanks

Please vote me if you are satisfied with my answer

The problem seems to be 2 things..

1.) firstly send the boot priority in the bios to HDD 0 or the harddrive connected directly to the board with the os.

2.) second thing, the Raiser Card, if it has raid Harddrrives connected via the ext. one of the raid harddrives connected to it is malfunctioning , remove and disable one at a time until u find the correct one. Or it could be the Card itself is malfunctioning.

I'm guessing here that you have a IDE card connected to the Raiser card with raid harddrives on it, One of them is malfunctioning.

Ensure drives are seated correctly and set up the RAID config.

Then on the Blue screen of Windows installation it will say "press f3 for 3rd party drivers", hit F3 (I think its F3), then insert a floppy disk with the drivers for you RAID controller, setup will then say it has found the followign drivers "your device xxx" then it should* pick up the hard drives later on in setup.

:) - RAID controller drivers can be got from the manufacturer websites.... normally.

Whatever is in slot 02 in your PC is faulty.

What is is OS? Do you need the drivers for the for the RAID controller? Which variant of the 226 is it? Feel free to contact me through my website on business servers, especially if you're near Rockville, MD

just bad luck

You could rebuild the defunct drive with the raid program on your server.

i don't know your type and model of your server.

8488 or 8648 and the model 3 digits.

for this you need serveraid manager

http://www-304.ibm.com/jct01004c/systems/support/supportsite.wss/docdisplay?lndocid=SERV-RAID&brandind=5000008

please do not update your firmware or drivers at this point if applicable.

if rebuild of a defunct drive doesnt work you'll need to change the drive. remember in a raid 5 you need min. 3 drives.

hi okey u have not mention which os ur installing pls go through this link it will help u much http://www-304.ibm.com/jct01004c/systems/support/supportsite.wss/supportresources?topicind=103&catselectind=0&brandind=5000008&familyind=5093441&typeind=5093452&osind=5118054&taskind=1 thanks