I think convergence setting menu appears and then goes off because STK392-040 does not work.
Please check supplied volts to STK392-040 and make sure there is no bridge soldering on STK pins or any other points that you worked recently.
All connectors are intact/ plugged properly that were removed in repair work.
If you need further help, let me know problem with details as "I replaced STK392-040 covergence appeared then quickly left." does not help me to understand what is the problem.
Thanks.
You may have blown again the recently installed STK. Test continuity on the resistors at the base of the convergence ICs on convergence board.
You should check the contrinuity of the stk as well as others. Most often more than one goes at a time, or one right after the other.
Did you check the Resistors or replace any resistors (3.9 ohm Ibelieve)? If not look there first. Did you replace both IC's and what were the symptoms b4 you replaced them. By "covergence appeared then quickly left" do you mean the convergence was all good and then it went out again? Too much missing info reply to this or post again with more info and try to help.
160 views
Usually answered in minutes!
There was no convergence I replaced the stk392-040 convergence came in but quickly left
no convergence I replaced stk392-040 convergence came in then quickly left
no convergence I replaced stk392-040 convergence came in then quickly left
×