2nd monitor doesnt work either

YOU GOT IT - LANDFILL!

Actually, had built in over the stove microwave, that "JUST STOPPED" working one day.

I looked around. You can get a good new Microwave for a very low cost these days (yes, it won't last forever, and will be more landfill - but that's how they make things these days)

Try dealnews.com - it constantly updates, and I got an awesome deal on a new microwave (with free shipping) must be 5 or so years ago ... it's still working great .... and I use it a lot.

Hi, Have you tried leaving it unplugged for about 30 min then switch the monitor on before you boot your comp up,
Let me know what happens ok

Either the belt has stretched, or the tensioner is not keeping it tight.
Or it has oil on it.

One year ago---your check engine light came on
The PO405 code was for an EGR Valve issue
No mention--- if you had that fixed

A Few Days Ago---you get Trac Light on,that is part of
the ABS Braking System
Now that system has to be diagnosed & repaired,not just
continue to use the car,actually make the repair, before
you do some damage or can't stop the car & worse things happen

Changing Trans Fluid---is NOT a FIX for anything,but should
be done on all vehicles every 3 years.

If the Engine Management System isn't working correctly,then
your trans won't work as it should either

You need to be proactive & immediately have any abnormal
operation or check light problems, at least diagnosed in a few days
of noticing them

You need to stop using any car that isn't 100% & have it
repaired as soon as possible.

Not wait weeks or years.
Being 9 years old, the trans may also have it's own issues

Hello
You may try another graphic card, it is quite possible the card may not compatible with board, also push the RAM stick to place them properly may the RAM gone dislocated.
Hope it helps

Make sure that your computer isn't going into Standby or Hibernate mode. You can test this by briefly pressing the power button and wait to see if the screen comes back on.

is what happen to your laptop is lower specs i thought..so you need to re-install the windows comptaible to your laptop and meet the specs...but before you do that you need to back up 1st your important files..

Try to use another keayboard, if that dosent work, try to do a full >CMOS reset.
error 25 is a weird 1 as although it's supposed to relate to gfx it's also been seen to be apparently associated with faulty IDE cables/drives & even keyboards

Good luck to you

If you know how to open it up and get to the power supply you will find three capacitors 2-820uf and 1-330 @ 25vdc 105o.they will have puffed up tops replace them. FYI the monitor has a 3 year warranty.

The compressor is overheating and not starting. Could be just the start relay. If this happens again try unplugging it for about an hour then it should work for a while. Heat between doors is normal this is an electric heater designed to keep the doors from sweating. You just noticed it because the refrigerator wasn't cold.