Unscrew the crown anticlockwise until it pops out then turn it clockwise about 50 times.
If the hand or date move, you pulled the pin too far. Push it back in and continue winding.
Watches are the best, I often treat it as a gift. http://www.mxracers.com/
I like this post, great. rolex watch for sale
×
SOURCE: how long does watch run after winding
35 hrs if you do not move it at all. If you wear it continuously you will never have to wind it again!
SOURCE: keeping 2008 breitling cockpit watch running
You have to wind the watch till it is fully wound (significant resistance should be felt).
It doesn't matter how many times you wind it (1 or even 40) - what matters is the strength of the spring.
Do as follows:
At any time in the morning wind the watch up till you feel there is no more winding left (should be quite tough). Memorize the time you did it.
Leave the watch (or wear it) till it stops completely.
Count the hours your watch did work (from the time you wound it).
Now you know exact power reserve for your watch.
It is advised to wind the watch 2-3 hours before the power reserve is gone.
Rate me.
, please.
SOURCE: Breitling navitimer watch
breitling navitimer, keeps perfect time on the desk, but when ion the wrist it runs fast, as much as one hour in 24 hrs
SOURCE: how to set date on breitling watches
On most. Turn the winding screw anti-clockwise until it clicks and pops out slightly. Pull it all the way out or half way out to change the time or date.
SOURCE: 1990 Breitling Chronospace instructions
Hi snapper,
I suppose when you're setting the time on your watch, passing the midnight marker the date changes. In that case you can go to the date funcion and reset the date.
Ciao
Giulio
3,992 views
Usually answered in minutes!
×