Over temperature signal from motor temperature sensor. Error can only be reset once the display reads E.nOH. Causes:
*Resistor at terminal T1:T2 > 1650 ohms
* Motor overloaded (getting hot)
*Temperature sensor defective
E.dOH Drive overheat, Overtemerature of motor PTC. error can only be reset at E.ndOH, if PTC is again low-resistance.
Causes: resistance at the terminals T1/T2 > 1650 Ohms
Motor overloaded
Line breakage to the temperature sensor............
Will helpfull
3,491 views
Usually answered in minutes!
×