Need to change bearing on kelvinator tdk600 ,bearing info and hiw to change

I have a Kelvinator kd12mm1 dishwasher. The normal and eco lights were blinking. I have to change the thermostat sensor and need to reset the dishwasher.

Here is the free help link.

Air Conditioner Repair Help

Here is the PDF. It does not list the problem you identify but lists the contact information for Kelvinator. Bear in mind your problem could be a blockage, a bad sensor, or oddly enough, the filter needing changing. This calls for a service technician.

https://theelectricdiscounter.blob.core.windows.net/images/air-conditioner/air-conditioner/kelvinator/pictures/e_series_inverter.pdf

if the noise is a rumble, then you have bearings failing. if it's a clunking then you have an issue with the springs. springs you can replace yourself, bearing / seal replacement is a little more in depth.

What is the exact model number?

If the monitor was set correctly at the factory, the color temperature should be close to whatever temperature the calibration tool reads. Your assumptions are correct as to the usual settings. Sometimes warm is near 4000k.

What is the model number of your unit? Is there one listed on the unit?

Hi

We recommend you contact Phil & Teds for assistance http://philandteds.com/uk/support/repairs-warranty

need more info .. how old is the frig . what style is it / top freezer / or sxs . / and which door .. need model # and serl # .. feed back pls .. mm

Hi!!

For this job, you"ll need R22 GAS gauge set. a GAS RECOVERY UNIT, a VACCUM PUMP and a WELDING TORCH among other things, unless you have the equipment, I recommend to contact an Air Conditioning Tech, to do the job.

Click below if helpful

If the fan motor shaft is smooth with 1 flat spot the hub on the blade probably has a hex set screw that can be tightned with an allen wrench. If the fan motor shaft is threaded there should be a nut holding the blade on. Also yur motor bearings could be going bad causing vibration which damages the fan blade.