Displays motor comm error - Life Fitness T5-0 Treadmill

Howard

• 115 Answers
• Posted on May 01, 2009

SOURCE: 9100 life fitness treadmill

Sounds like you need a new lower board replacement. You can get that for that treadmill by call lifefitness or sportsmith.com Please rate me good

I’m happy to help further over the phone at https://www.6ya.com/expert/howard_079189dd4959a511

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

SOURCE: my life fitness t30 treadmill ''running error''

startup error on life fitness treadmill

SOURCE: error 1 message on older life fitness t3 treadmill

Error 1 - Start up error. This is caused because the belt was commanded to move and the opto (speed sensor on the motor) has not seen any movement or the belts movement was interrupted prior to it reaching its commanded speed. To fix Verify opto operation in Diagnostics, Motor Test
Mode, Section 2. Verify DC voltage at connector P6 pins 1 and 2. Verify that LED 4 on the Motor Controller flashes as the motor moves. Let me know if you need any more help. Fitness Fix-It

SOURCE: FET Error

FET error is caused by a short in the driver transistor on the motor controller. Unfortunately, the fix for this is to replace the motor controller.

SOURCE: Fet error message

The FET error message is caused by the driver transistor on the motor controller has shorted out. Unfortunately, the fix is replacing the motor controller.