HP PSC 1210 prints fine, but won't make copies anymore.

Put more paper into the paper-tray.
Be sure that the paper "seats" correctly into the paper-input slot.

Click here for instructions on how to resolve this issue.

Try removing the paper and replacing it with a heavier paper > pull out the 20# copy paper and replace it with 24# bond or 60# offset. ( The 24# and 60# are the same weight just different finishes on the surface ). Assuming your paper tray is one that slides in and out, close they tray firmly. Turn the printer off, wait 10 seconds then turn it back on. If the problem is still there, look VERY closely at the edges of the feed tray / compartment. There will be a very thin wire that the paper will depress when it is loaded into the feeder. If that wire gets bent the paper may not reach it to depress it. The printer does not sense any paper if this happens. Bend the wire outward so the paper can depress the sensor switch. Hope this helps.

Similar but not the same: HP Support website for the 1200 below: 

http://h10025.www1.hp.com/ewfrf/wc/product?product=240978&lc=en&cc=us&dlc=en&submit.y=3&submit.x=5〈=en&cc=us

HI,
DEAR TRY COPY A PRINT i mean print out not from your system jast put a paper in to your secner and copy it if the printer do it.then reinstall your software
if not then you have to repair it from your nearest printer repair shop.

i lost my hp psc 1200 all-in-one printer driver and pl send me install driver. my email id [email protected]

if cleaning wont work & cartridges are most 6 mos, trying a different cartridge will fix it

hi,

this seems to be a hardware problem..... anyway try this...

> unplug the powerchord
> open the rear access door, and check whether there is any paper jammed or any bit of paper or thread stuck inside.... if so remove it
> clean the rollers using a lint free cloth
> close the rear access door
> open the door so that you will get full access to the cartridges...
> move the cartridges to and fro for several times manually with your hand
> close the door
> plug the power chord
> try again to copy multiple pages


thanks and regards
agnel

Hi,

Please check the printer status at control panel printer properties if it is offline or ready. Restart your computer if necessary, you will notice all pending jobs will be printed as long as there is no problem with the connections of cables and drivers. Note: Do not cancel printing jobs in the middle of sending data mode to printer or queing instead you have to remove all papers on tray and wait for the error "paper out or empty" then there click Cancel. Hopes this helps.

Best regards,
Rosener Guyano

First off, I will try an uninstallation of the printer
Then reinstall all the drivers and software for the printer.