SOURCE: Need to know where to get a manual for Jet 3 Ultra
http://www.pridemobility.com/jazzy/jet3.asp
this should be of help.
SOURCE: Wife's Jet 3 Ultra ; The Owners Manual Mentions a
liv If you look under the front of the chair below the footrest and can see the lower front of the battery tray there is a 50amp circuit breaker on the front right side of the tray. The circuit breaker is mounted in the tray and I don't know if you have access to it without removing the seat and lower shroud. I have seen very few problems with this tripping unless there are battery issues or old motors drawing too much current. Just don't put the chair in a bind like up against an object and trying to make it go forward in full speed. You shouldn't have problems with a new chair with this tripping. Hope this helps you
SOURCE: I HAVE A JET 3 ULTRA CHAIR, WE LOSS THE 24V PRIDE
You can use the AC charger cord from a computer as a replacement for the AC cord of the charger. If the AC cord plugs into the wall and plugs into the charger or charger receptacle on the back of the power chair, you can use it.
If I remember correctly, This chair has a 4 Amp on-board charger which has an AC receptacle on the back of the chair to plug in an AC cord. The off-board chargers take a universal AC cord which will work with a universal computer AC cord. If the AC cord plugs in, use it.
SOURCE: How do I know if my jet 3 ultra is charging? I
The chair should have a meter on the rear panel where the 9 pin connector for the joystick plugs into the chair when you plug in the charger cord the meter should move up and the lights on the joystick should flash indicating the charger is plugged in. When the chair is fully charged the meter should read zero or bounce up and down. Hope this helps
SOURCE: I BOUGHT A USED JAZZY
Locate the two wires from the circuit breaker attach one wire (black if marked) to the negative post of the rear battery and attach the other wire (red if marked) to the positive post of the front battery. Locate the two wires coming from the power module plug with a red and black wire. Attach the red wire to the rear battery positive post and the black wire to the front battery negative post. attach the joystick to the nine pin plug at the rear of the chair and turn it on. You should have power at the joystick and the chair should work. Disconnect the joystick put the shroud cover back on grease the seat post and reattach the seat then plug in the joystick and charger plug at the rear of the chair. Charge the batteries before use and charge them overnite for the next 20 days. If you use the chair daily charge your batteries everynite while you sleep unplug in the morning. If you don't use the chair daily charge at least once per week or after you use the chair. Always put the chair up fully charged if you are going to be out of the chair for an extended time the disconnect the batteries at the large plug going to the power module Hope this helps you
120 views
Usually answered in minutes!
×