Can you mix spironlactone with alcohol?

Near the center of the paper lot there is a little "eye" that detects the paper. You will probably need a flashlight to see the eye. When it gets covered with dust it thinks paper is there all the time. Dip a cotton swap and some rubbing alcohol and clean the detector eye.

Do regular prints look ok? If so, then try copying something from the flatbed glass. If that copy has no line then you have something on the glass where the paper passes over when fed through the adf, clean the glass well, you may need to use some rubbing alcohol because often fine bits of adhesive from things like sticky notes will cause the lines but are not obvious to the eye when you inspect the glass.

Mixing an energy drink with alcohol should be avoided. Many studies have found that combining the two can be even more dangerous than drinking alcohol alone. Mixing the two can possibly increase your chances of suffering from heart palpitations.

For more information about this topic, please click on the link below...

http://www2.potsdam.edu/hansondj/HealthIssues/1043185105.html

Sounds like one of the universal joints on the drive shaft is going out.

if the system was hot and got bumped the eye may have went out. This was only a problem on the first and second run of the 70000 series. you can look on the back of the unit and it should have a model number. You can try cleaning the eye with alcohol on a q tip but do not apply very much pressure.

Depending on the cleaning mix probably not, but it will taste like hell, hence your husbands reaction.

Look at the instructions of the cleaning mix, and check the contents on the Internet for any possible reactions. If I were him I would drink lots of water, and if he has any new symptoms, I would go to the hospital.

Good Luck and I hope he is OK

the eye on the cd that reads the cd may have dust on it don't put a rag on it get a dust remover spray at walmart and blow it into your cd drive and it might be faster and not as loud.

Clean the eye... try another disc, apex usually pretty robust unit. Glass eye near center spindle, clear alcohol, swab gently.
Loading indicates unit doesn't see the disc..

clean the eye. look inside near the cd spindle and there will be this glass looking eye. Hopefully it's dusty..pure alcohol and very lite swabbing.