Pairing h700 i charged my h700 and... nothing. nothing happen when im opening it. trying to pair... nothing. the purple light disapear after few seconds

The H700 is a little picky when pairing.
Make sure the H700 is fully charged.
1. Leave the H700 Microphone closed and hold down the button until it turns purple. 2. Once the light is purple, open the microphone. (If it turns blue then start over. This is normal operation mode not pairing.) 3. Go into iPhone Settings>General>Bluetooth and turn Bluetooth on 4. H700 should appear on the screen. Select it. 5. If the device asks for the Device PIN, enter: "0000" 6. The two are now paired.
The H700 may leave pairing mode during the process. This is the pickiness I mentioned. If it does then just restart the process. It may take several tries or it may work on the first shot. Just be patient.

First off, you want to have the H700 fully charged up and it's probably good to have the phone fully charged up too. Now turn off the H700 (the ring around the talk button should not be flashing blue every few seconds) then push the talk button for about five seconds, until the ring around it displays a purple color. Immediately let go of the button and flip open the tiny microphone extension. Now it's in pairing mode and you can leave it while you fiddle with the phone to finish the process

Close boom press call button till light turns purple then instantly open boom, ta da, you just forced it into pairing mode! The purple light will be steady untill you finish pairing the two devices.

http://khaoohs.wordpress.com/2007/11/16/motorola-h700-bluetooth-blackberry-pairing/

this actually works.

I signed up JUST because this solution worked:

"Hmm this may sound like a stupid solution that doesnt work but what i did is...,

#1 I Held the button to make the violet light go on
#2 when the violet light is on dont just flip the boom mic, flip* the earpiece with it.

*note: when fliping the mic and earpiece, dont open slowly, flip it open fast and keep it there." I do want to note that my passcode was reset to nothing during my 3 months of troubleshooting.

Not going to mess with it.

Thank you. I called a 1-800 number for tech support but they told me I had to wait 14 days from the date of purchase before they could help me. Your suggestion was right on the money. Thank you.

Is the Samsung bluetooth turned on?

Steps to pair a H700 headset with any bleutooth pone:

1. Make sure the H700 fully chared (very important)!!
2. Make sure the microphone boom is folded closed, i.e. power is off!
3. Hold the call button for 1-5 seconds until the light is steady lit purple
4. Flip out the microphone boom, the light should stay lit purple!

Now you are ready to pair the headset with your phone, so follow the pairing instructions of your phone.

Note: When prompted for the Passkey; it is most likely 0000 but the correct Passkey should be on the headset accessory instructions.

I must add that indeed my headset on occation (once or twice every three months) also loses its connection with the blackberry (a 8703e) . At which time I have to remove the headset from my phone bluetooth device list, and start the above described steps to pair my headset with the phone again.

It's important to note that the pin has to be entered while the light is still violet. On the phone, begin searching for bluetooth devices. With the boom closed, hold the center button until the light turns violet, then immediately flip the boom open. The phone should immediately find your H700. However, to pair successfully, you must enter the pin (0000) while the light is still violet. If the light goes off, close the boom, enter 0000, and while the phone says processing, hold the center button until the light turns violet and flip the boom open. The light on your H700 will turn blue, then flash rapidly, and your phone should say that it has paired successfully.

First: When charging the light should be steady. If the battery is less than 20% charged it should be red. More than 20% it will be yellow. Fully charged it should be green. Make sure your microphone is closed when charging.

Second: Have you "Paired" the H700 and the phone? If not you need to. To put the H700 into "Pairing Mode" do this:

Make sure the H700s microphone are is in the off position. Push in and hold the button on the H700 until the light lights up purple. Release the button and quickly open the microphone button. The light will stay purple and you are now in "Pairing Mode". Now follow the instructions for your phone to pair with a BlueTooth unit. When it asks for a code, use 0000 (that is 4 zeros).

Your phone and H700 should now be connected.

Hope this helps a bunch!!!