My serial 3 is correct, but I get a reply that it isn't

Those parts are very common and cheap to buy. The problem is your model number isn’t correct. Leave out you serial number and re-check the model number. When dog agits go bad, the bottom half of the agitator should still work.

It should reset itself after an hour and will allow you to try again and I believe it gives you 3 tries. If you find you don't have the correct code and are in need of the correct code, you can reply/comment here on fixya or feel free to email me directly at [email protected]. If it does come down to needing the correct code I will need the serial number off the radio. The serial number should begin with the letter "M" followed by 6 numbers. I have some decode software that goes by the serial number. Hope you get "tunes" back in your pick up and I hope I was able to help....

change the needle
clean under the needle plate area & in bobbin area for loose threads & lint
make sure the thread isn't coming off the thread take up lever
since the machne has not been used in about 3 years it may need to be serviced

click start control panel administrive tools computer management device manager scroll down universal serial bus controllers you could see a yellow question / exclamation mark? ! or a red X

you will need to update/reinstall drivers

right click to reinstall drivers

if you can see your usb drive but its not working

ports(com&lpt)right click update driver if this fails to fix the problem

check the USB leads that attach to the motherboard usually red white green black make sure they are securely seated and have no dust build up on them dust will cause static and a lot of unforeseen problems for a computer and its parts

make sure the battery is good (has full charge)also you might test the usb device for the mouse is inserted correctly into the usb port (if applicable)

if you need more help with this post a reply

hope this helps you

plese reply my email gta panjab serial number

Getting a serial number that isn't the original is kind of illegal. If you lost it, I would try calling the company that made the game and talking to their customer service.

Hello. You can try these serial numbers for your Windows Xp Pro Service Pack 3:

Hrcxt-by6wb-vbm83-cmbxf-bvwyy

Myhvt-wq49m-qrpvf-v86fc-p3r8y

Btfrc-ghc7v-2wfbw-y42xw-9wdky


I didn't find any serial numbers for Windows 7 Ultimate Edition

Remember that you should always buy the original software instead of downloading it!
If you have any other questions, please leave a reply!
Thank you for using FixYa!

Hello again Rudy.
Please reply below (Add Comments) with the serial number of your saw then I can investigate a little further.
You can reply even when the question is closed. I am not certain how but I get email notification of your reply when done correctly. If equipped the oiler adjustment is below the crankshaft on the clutch side. Look up from the bottom. On the side of my 359 is an icon of a link of chain with a drop of oil above it. The oiler adjustment is aft of that and can only be seen from the bottom of the saw. The manual I saw said 3 position only with CCW (3 - 18 to 20" bar) most oil. Forcing it beyond the stops causes a lot of problems.
http://weborder.husqvarna.com/order_static/doc/HOUS/HOUS2007/HOUS2007_1150331-95.pdf
Page 36
Is your serial number is between 07 18##### and 08 17#####?
Page 5 item 1 shows location of the serial number. Not all newer saws have an adjustable oiler. Please reply below.
Lou