Stanley TR 150 staples only going in half way. Why?

Arrow T-50 heavy-duty staples 1/4-in to 3/8-inch

Don't hold your breath - I tried to get spare parts from Stanley before which resulted in a lengthy lecture from a woman at Stanley about how Stanley products don't need spare parts, how if something breaks or goes wrong while under warranty it is replaced and if it is out of warranty you just throw it away because "you have had your money's worth"...

I did try once to buy a staple pusher for an Arrow staple gun. It was theoretically available but clearly priced not to sell as it was only marginally cheaper than buying the whole staple gun...

Stanley Model TR45 Light Duty Staple Gun Review - YouTube

? 3:35
https://www.youtube.com/watch?v=hWmvXhkqnYI
Jul 25, 2012 - Uploaded by Vansvideoreviews
Stanley Model TR45 Light Duty Staple Gun Review ... How toPut Staples in a Craftsman Stapler (Model 968447) ... Stanley SharpShooter Manual Staple and Brad Gun review - Duration: 9:35. by Unpack Guy 35,948 views.

How to load staples into a Stanley Stapler - YouTube

? 2:11
https://www.youtube.com/watch?v=j4Q5W0uKS-s
Mar 26, 2013 - Uploaded by David DeStefano
This video shows you how to load staples into a Stanley StaplerModel # TR110. ... Stanley SharpShooter Manual Staple and Brad Gun review ...

put stanley sharpshooter staple gun back together ... - Fixya

www.fixya.com > Forum > Tags

Find solutions to your put stanley sharpshooter staple gun back together question. ... staples for the TRE500 Stanley Sharpshooter Electric Heavy Duty Stapler.

Check this

It sounded good but made no sense. How do you remove the trigger/ squeeze handle assembly? This thing (Stanley TR70) is riveted together. The only piece that is removable is the staple feed tray.

Ive had the same problem where it was putting divits you could see from the staples, we ended up changing out the flooring completely. Only thing besides trying diff psi's to get it perfect and different length staples/different heads on staples(nails) , maybe try staple gun. Keep trying every woods different, odd that it started half way through job.. odd.

Go to this link.

Make sure that you are using staples made for this tool. Remove the staples and look for a jammed staple at the drive head which will block further staple movement. Make sure there is spring tension at the rear of the staple row when the slide is closed. Hope this helps!

very simple to fix it 1 pull the trigger all the way out 2 there is a little piece of metal, pull it all the way out (detach the piece out from the gun) an connect one side of the spring 3 push the piece back on the gun. 4 on the other side of the spring tide a little fishing line 5 pass the fishing line over a small rounded piece and pull it hard 6 finally connect the side of the spring onto a little hock on the base of the trigger

Generic comment.

There should be a pin or a screw (probably with a locking nut) on the business end of this machine. Find it, remove it and the track should pull down allowing you to clear the jam.

I hope this helps

a