What does a e5 code mean on a haier refrigerator

Question edited for a lot more clarity and for spelling.
Question moved from Super computers category.

Are you sure it it a refrigerator and a refrigerated AC unit?

Super General AC error code e5 "E5" - Fan Motor Problem: Occurs when the over current from the fan motor is detected. Solution: Verify Power (Voltage/Amps).

Common Portable AC Error Codes - Priority Rental

https://www.google.com/search?q=Super+General+Refrigerator+Error+E5

Hi Brett,
When the Haier refrigerator shows an error code, try this before replacing any parts or taking the refrigerator apart...
- Power the Haier refrigerator OFF for 10 minutes, then power back ON. (Unplug the refrigerator for 10 minutes) -
The error code may disappear after a reset is completed.
- If after removing power to the refrigerator in an attempt to reset, the error code comes back,the freezer fan is bad and need to be replaced.
Here is a link to Haier Parts.
Also make sure there is No Recall on your particular model or serial.
Best of luck,
JP

https://www.haierappliances.com/parts

you can go and google to get the reason for the error code E5. You will need to put in the model# along with the brand.

Change capacitor motor and outdur working almost
But 3 minute working ok
After E5 error show display screen on indur with outdour fan stop but compressor sound

E5 on Freezer Display Ambient temperature sensor error Unplug the refrigerator and check the wiring connections in the ambient temperature sensor circuit. If the wiring connections are okay, replace the ambient temperature sensor. If the problem persists, replace the electronic control board. Ambient temperature sensor, Electronic control board

Problem
Overheat of inverter compressor motor

Cause
Shortage of refrigerant amount Leakage of four way valve
Defect of connector contact

Hi friend, I appreciate your post!

I understand that your Electrolux refrigerator is showing an "E5" error code and not cooling. "E5" typically stands for Showroom mode, you can press and hold the "Up" and "Down" keys simultaneously and that should restart your refrigerator back to normal operation. Could you reply back if that corrected the issue? Thank you. -Matt

See: haier com

Bsically, not managing to fill within "normal" time

E1 is normally a temperature probe failure -

It means to change the water filter. They are expensive and only last about 6 months a piece.