The type of scanner that can be used for canofile for windows?

Try this, tape it to a sheet paper.

Check if there is enough disk space in the comp target area. Run defrag and scandisk.

S. Mohan, india

First ensure that the SCSI card is installed properly. Download DR 5020 drivers from http://software.canon-europe.com/products/0000672.asp and install them. Use CapturePerfect ver 2 or 3 to scan documents. With SCSI based scanners/devices, one should power-on SCSI device first before starting the Computer.
S. Mohan, Chennai, India

You can down load drivers from Canon Europe site. http://software.canon-europe.com/products/0000672.asp

S. Mohan

Go to the help menu of Canofile and check to see if there are updates available for your program at the manufacturer's web site. If you are using a newer version of a microsoft operating system than the software was made for, you can also try to set the program to work with an earlier version of Windows. Right click on the program icon, then go to properties and click the compatibility tab. Or, go to accessories, tools, program compatibility wizard.

Finally, you might want to check with canon to see if there are plug ins or updates for both your scanner and program. Thanks, I hope this helps.

CapturePerfect ver 3 is on chargeable basis! You can download ver 2.0 from http://software.canon-europe.com/software/0022439.asp?model= Though this is listed under Canon DR 5020, it works fine with DR 9080C. DR 9080C has very intelligent features and ver 2 works fine. I do not know if there are addl features with ver 3.0. I have used for scanning over 500,000 docs.
S. Mohan

There is fuse, but in the Power supply board. Check if LEDs are blinking in the back PCB and on the right side. Do a basic check also, check if the power cable is good. many times we assume that is perfect, but not necessarily.
S. Mohan

. Have you installed DEvice Driver? Download item no 5. in this link http://software.canon-europe.com/products/0000672.asp
This should solve your problem.
S. Mohan, Chennai, India

Wipe the rollers with a damp cloth thoroughly. Remove all the dust in the glass for a claen scan. The red color roller roller in the bottom needs thorough cleaning, rotate with hand gently (in power-off mode) and clean it thorughly. No solvents pls, except Isopropyl alcohol for cleaning
S. MOhan, Chennai, India

If the line is disappearing with a lower contrast, then it is definitely scaratch/glue/dust on the glass. Clean with Isopropyl alcohol. Dont use solvents.
S. Mohan, India