Pushing joystick forward and it wants to pull more one way that the other.
I suspect that your seat is out of alignment.
On the control side of you unit there is a lever which allows you to alter the position of the seat so if you lift this up and forward you should be able to 'square your seat' in a for and aft position.
Be sure to return the lever or else it will be quite unstable.
Joe
SOURCE: pride mobility Jet 3 Ultra Power Chair 7 flashing
a 7 Flashe code. There is a joystick fault. Make sure the joystick is in the center position and then power off and on again. Check all your couplings. make sure when turning on the unit you only mash the power button for 1 sec. 2-3 sec will put the unit in "Lock out mode".
This ierror will also be present if the joystick is off center when powered up. If you experience these symptoms, you must first make sure there is no physical damage to the joystick preventing it from returning to the center position. Then turn the power off and back on again (making sure the joystick is not depressed in any direction. If the joystick repeats this error, the controler much be replaced. [email protected]
SOURCE: we have a problem with the joystick controller on
The joystick is a sealed unit. If there is a problem with the joystick then you have to replace the whole unit.
SOURCE: I just purchased a used
bobby
The batteries are not charged. The red light indicates low batteries and the clicking sound you hear is the electric brakes being energized. Now the problem could be bad batteries or a bad charger. If you have access to an off-board charger (maybe a friend or acquaintance might have one) plug it into the charger port located under the front of the joystick. Don't plug in the on-board charger at the same time. Charge the chair overnight with the off-board charger and you should see a red light(power) and a green light(if the chairgot fully charged) if the light is still yellow then the batteries are bad and need to be replaced. Your chair uses 2 U1 batteries and if there is a battery store near you get them there. Interstate makes a good battery if you have a dealer near you. Hope this helps Good Luck
SOURCE: Hi i have a Jet
Good day,visit the manufacturer website & go from there.Alternatively,ebay is a trusted site to purchase parts also.Have a nice day,Colin.
The above solution is very good idea one other thing that is easy to over look is make sure the trans engage lever is in drive and if the trans is locked up you can find motor and trans. combo on that site E-b@y I hope this helped.
LOCKING/UNLOCKING THE VSI
The VSI has a feature that enables you to lock your power chair to prevent
unauthorized use.
To lock the VSI:
1. With the VSI powered on, press and hold the on/off key. After one (1)
second, the VSI should beep.
2. Release the on/off key.
3. Push the joystick to the full forward position until the VSI beeps.
4. Pull the joystick to the full rearward position until the VSI beeps.
5. Release the joystick. There should be a long beep.
6. The VSI is now locked.
To unlock the VSI:
1. Press the on/off key and power on the VSI. The maximum speed/profile
indicator should ripple side to side.
Good Luck
mimobility
117 views
Usually answered in minutes!
×