How do i wire a toyota granvia starter motor - Metra Car Audio & Video

open glove box take out guide, see fuse page ,FI fuse is common name.
or tell facts.
20+ Petrol engines, non told, world wide( I can not guess them)
year is? 1967 to 2004? vast exits by year,engine/country)
no country told
or RTM read he service manual. ?
ask toyota for the manual , in you country
non in USA or I could read it to you.


all Regius are here, 1989 to 2004 ,
or is it REgiusACE?

Granvia, HiAce Regius, Grand HiAce, Touring HiAce (XH10, XH20)

https://en.wikipedia.org/wiki/Toyota_HiAce#Granvia,_HiAce_Regius,_Grand_HiAce,_Touring_HiAce_(XH10,_XH20)

videos in the link

https://www.google.com/search?q=Toyota+Granvia+replace+heater+fan

..

check track --sensor --motor

There's this website www.reliable-store.com
They have books on ALL vehicles.
it covers wiring diagrams,
electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, owner's/service/repair/parts/maintenance manuals etc everything totally..
I have 1987 toyota 4runner model and I keep servicing and when needed repair it on my own. worth it !!!

for better result download the pdf file
1996 Toyota

Replacing brushes on a starter motor is not a job for a novice. However, the procedure is simple. Remove a battery cable, best to remove the earth cable.
Now get yourself in under the vehicle and identify the starter. There should be at least two wires, usually more on the solenoid. One is the positive battery cable, one is the solenoid actuator wire which just pushes onto a spade connector. Any other wires are connected to the same terminal as the battery cable. Remove all these wires from the solenoid.
Either two or three bolts attach the starter to the engine block. Remove these bolts and voila, the starter is out.
Have fun.

The compressor is fine, if the rear unit operates. Check your front blower fan for a loose/ broken wire or blown fuse.

your motor is shot

Hi....
On your Toyota TRuck.
The Starter motor only have 2 Wires.
1- come from the BATTERY , Attached at the starter with a 12mm nut. constant 12v. normaly red.
The other one is Small attached to the Starter Selenoid , from the starter RELAY when starting.
Normally Black/white.

OK. If the Vehicle is not starting, Check the Neutro safetly switch.
LOcated on the Clutch pedal .

Inspect the Starter relay and starter Fuse, Located on the Engine fuse Box.


Ok... I hope this help on your question.
If you need more info feel fre to ASK.

Thank you for use fixya...

Your e-mail was way out. Toyota Granvia is a motor vehicle. Problem has been resolved, No need to add my mystery to your list.