Console to asa 5520 - Cisco As2511-rj Universal Access Server 1yearwarranty 2xavailable Ask More Qty

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/pppoe.html

hi,
when u login in ASDM you can find on right side services and u create one whre u add which all ports u want to and apply that in ur rules

mode exec user Router)
ping ip
show ip route
show version
traceroute ip

mode exec priveligiado
show arp
show interface
show protcols
show ip protocols
show startup-config
erase startup-config
reload

You may refer to the steps in the link below:

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/trouble.html#wp1049302

I hope this helps!

possible solution;
1-turn off and turn back on
2-open the cover and check the power supply and LED

If you are going for factory reset use the following commands

asa>enable
asa#write erase
asa#reload

Dont save the configuration when it prompts for it.

if you want to restore the configuration from the backup

1. You need to have a TFTP server
2. Locate the config file on your TFTP server
3. TFTP server should be reachable from ASA

then

asa#copy tftp flash

give the tftp server ip address
give the configuration file name (as exactly on the TFTP server)

reload

Hi,

The crossover cable should work fine for sure.

Best Regards,
TL

Voila un link pour un bon simulateur:
http://networksims.com/pix.html

Hi Hemalsj,

Did you enable multicast-routing?

Hope this helps:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807631d2.shtml


Regards,

ex_ocsic-cat

I had this same issue on my ASA 5520.

1. Copy the config and IOS image to a tftp server.
2. Format flash (disk0)
3. set rommon server, ip addy, and file settings.
4. tftpdnld
5. Once the system has booted to the image copy the asa image file, asdm image file, and config to flash
6. configure asdm image default location and reload