New cartridge installed correctly, yellow toner light continues to flash. have shut off machine and repowered, no effect.
Could be photoconductor at end of life.
You shoul still be able to do a printer test print (press the arrow button).
Look on the printed pagesfor Toner AND Photoconductor.
These show as OK when new or very low count, and 100% when fully used.
If the toner is showing as 100% when you've just replaced it, either the chip is faulty, the wrong one, or if the cartridge is a remanufactured one possibly nor been replaced.
After installing a new cartridge and the blinking light is on Toner Low, it means that the photoconductor is almost full and should be replaced soon. Press and release the Continue button (green button) to clear the light sequence and continue processing the print job. If the light is still blinking, replace the photoconductor kit.
For further assistance, please call Lexmark Technical Support.
The printer is ready to receive and process data. In addition, the toner in the toner cartridge is getting low.
You can press and release Continue button to clear the light sequence and continue processing the print job. Turn the printer off and remove the toner cartridge, and shake it to extend the life. If toner light is on, replace the toner cartridge.
For further assistance, please call Lexmark Technical Support.
2,002 views
Usually answered in minutes!
I have the same problem and also the paper has blank marks all along the right edge.
I have tried changing toners, turning on and off.
Help//
Our toner light is also flashing and we have black roller marks on the right hand edge also. I printed out the Device Statistics and it indicated the photoconductor supply level is low (close to 0%). The photoconductor is the component that the cartridge is slotted into.
I've ordered a new photoconductor and I'll let you know if replacing it stops the light blinking and fixes the black marks on the edge of the page.
Do you stll need help with your printer?
×