Our washing machine is beeping through the whole cycle and the screen is flashing up DF, can anyone help us fix this problem?
DF means the temperature sensor is faulty. Replace it. Get a new one from your Simpson agent. Turn power off. Open panel by removing the 3 screws at the rear of panel & swing it up. If you are standing behind the machine look on the left hand side at the top of the circuit board. You will see a small white plug with 3 wires (red-white-black) Very carefully pull this plug toward you off the 3 pin base. The other end is the sensor pushed into the water inlet chamber. Pull it out. Push new sensor into water chamber (make sure black rubber o-ring is on it) Push wiring plug back onto 3 pin base. It can only go on one way. Do not force it or twist it as the 3 pins can be easily broken or damaged. Then close panel & power up.
I have the same problem with the same washing machine: Simpson Encore 806. I followed the instructions suggested above. I bought the part suggested (temperature sensor) replaced it, screws back, turned machine on and error message still shows. There must another meaning for dF message.
1,557 views
Usually answered in minutes!
×