Pioneer djm 500 Mixer schematics

You could have quite easily have blown something internal.

You need to REPAIR the cause of it blowing before you worry about what size it is. Replacing it without repairing MAY damage additional components.

For 220 Volt service it appears to be 250ma for 120 it appears to be 400ma

Here is service manual:

http://elektrotanya.com/pioneer_djm-400.pdf/download.html

Hi,

Seems that the power supply is down.
If your not a technician, visit one or bring it to your local dealer.

regards,
Gerard

no and you can use channel fader of each channel to control the channel without cross fading.

email me [email protected]
I have many service manuals available

I have the full manual, email me
[email protected]

Use a male Twin Phono to 3.5mm stereo jack plug lead. The two phono connectors need to be male, so that they can plug into the red & white line sockets at the back of the DJM 500.
Are available in any audio products store.
Regards
Rob

are you sure you have your tt's plugged into the phono line with the master booth knob turned up? Check the mixer too cuz the techs should be square.

could be a few things , what have you tried to trouble shoot the problem ?
My steps would be ;
check all leads (even if you KNOW u pluged them in)
check the gain is set corectly .
check the line phono slectors are set to what ever you have you leads pluged into on the back of the mixer ( there is 4 red and white RCA plugs , 2 for phono,2 for line CDJs shold be using line )
if you are using digital cables to conect your CDJs , on the back on the mixer there is a small switch marked "CD or digital" make sure that is sleceted "digital " . if ur not using digital cables make sure it is on "CD" .
the info iv put here is based on the DJM-800 so your mixer my not have some of these featers as iv never used a 400 . hope this helps dued . check out www.djtutor.com for more tricks and tips . Pratices'N'enjoy !

send out from mixer---------to pioneer in---------from pioneer out-----to return in mixer.