Dishwasher was tipped and won't run

Thermostat should be in the base of the dishwasher next to the heater element and looks like this part.

http://www.espares.co.uk/product/es567728/dishwasher-temperature-sensor?PartTypeId=1532&ModelId=576996

Thermostat should be at base of dishwasher next to heating element and looks like this part.
http://www.espares.co.uk/product/es567728/dishwasher-temperature-sensor?PartTypeId=1532&ModelId=576996

remove RHS panel and you will see it bottom right. looks like a round cylinder with wires going into it.

if not heating worth looking at main board as wel for a broken solder joint on heater relay. bit of solder will sort this

Hi,
Check your heating element..

Dishwasher Problems The Heating Element not Working
http://www.fixya.com/support/r4589033-dishwasher_problems_heating_element_not

Dishwasher Maintenance
http://www.fixya.com/support/r4319937-dishwasher_maintenance

heatman101

Hello,
You seem to have a blockage,have you checked the filters lately.Also check the drain hose and the pipe that the drain hose goes into,if they are clear then the blockage is down in the bottom of the dishwasher in the pipes or the drain pump.

Hope this helps.

Hi,
Check your heating element..

Dishwasher Problems The Heating Element not Working
http://www.fixya.com/support/r4589033-dishwasher_problems_heating_element_not

Dishwasher Maintenance
http://www.fixya.com/support/r4319937-dishwasher_maintenance

heatman101

Make sure you unplug before you start. I had the same problem with a DE6850. The heater was ok. Metered at 25.ohms. Apparently, the relay on the control board mounted in the front door behind the switches is a common fault. Remove the screws around the top part of the door and you will be able to get at the control module. Resolder the connection. Zanussi reliability has been lost. Noel P

is your water heater set on 120 degres

Sounds like a heater problem to me, does it go through the complete cycle on its own?

most probably the pcb unit...had a few of these changed pcb and cured fault, not a job for a novice to be honest, think the parts is about £70-80 from memory.. ally