How to set the color on my faceplate. It contnues to change color

ok change tv set

Well you need to buy a faceplate or fascia for your Nokia E65. I receommend ebay. Looks like they are about 10 dollars for the set.

Check out the following link for a guide video guide and links showing what is available on ebay.

Change Faceplate on Nokia E65

how i set my pioneer 3050ob car deck clock setting

had the same problem with a pioneer i took a qtip and some rubbing alcohol and cleaned the gold colored connecters on the face and radio and worked ever sine.

This is a common size metric torque screwdriver. Visit your local auto parts store, Radio Shack, or 2-way shop to borrow or purchase the torque.

It you are not getting any error lights at all when you turn it on it is a power issue. What color lights are on the power supply when you plug it in (before powering the 360 on) and what color lights do you have after you try to power it on? Orange means the power supply is in stand-by mode or the plug is not correctly plugged into the system (when you try to power it on. Red means the power supply detected a fault, it is either too much current, to little current or overheated power supply. Plug the power unit directly into a wall outlet, no extension cords or power supplies. Has you son changed or played with the faceplate? Sometimes when you remove or change the faceplate they don't seat correctly and the power button on the faceplate does not contact the power switch under the faceplate. My guess would be an issue with the power supply so I would start there first.

Best,
Bob

only the display changes colors.... your deck is doing what it was designed to do!

hp3420 printer driver

Sounds like you might need to clean the contacts on the back of the faceplate or the ones on the front of the actual unit.

Your display lights are burnt out. This is a common problem. It is covered under warranty. Send it to Sony for service. Anyway, under the Sony faceplate there are two small, different colored leds which control the color. The light is aparently transfered through pieces of clear plastic (best example I can think of is the piece of plastic over the led in a household smoke alram)to most of the buttons and the backlighting. If your display has burnt out you may just be able to swap the leds for new ones. As for the intermittent green could it just be a faulty solder on the board.