Need drivers for usb-ant? - YDI Wireless Extended Range 802.11b Access Point (ap-ant)

Voy a describir el procedimiento tal y como lo hice y logre revivir mi impresora.

1. Utilic? un equipo en el que jam?s fue instalada la impresora as? no instalar?a el driver autom?ticamente. (No s? si funcionar?a desinstalando el driver de la propia PC)

2. Conectar la impresora al equipo y esperar a que muestre el mensaje USB AVAILABLE. (IMPORTANTE. no instalen el driver de la impresora. Windows la reconocer? mas dar? error al no encontrar un driver compatible)

3. Descargar la utilidad de actualizaci?n de canon Win_MF4800_4700_FirmUpdateTool_V1504_usEN.exe

4. Ejecutar la actualizaci?n de Canon. Esta actualizaci?n deber? detectar el firmware da?ado y proceder? a actualizarlo. En mi caso fue el N?mero 4.

NOTA: es importante disponer de una fuente de respaldo (UPS) ante probabilidad de fallo en el suministro de electricidad ya que ante un fallo como este quedar?a la impresora inservible.

Use ant bait that they will eat and take back to the other ants.

[ANT] Simple is a tiny program that reads the security code of any Nokia phone that supports USB connection mode.
1. Downoad [ANT] Simple
2. If you have Nokia PC Suite running, be sure to close it by exiting from the taskbar icon.
2. Extract [ANT] Simple ] and run Simple.exe located in the folder
4. Connect the phone vis USB to the computer
4. On the MAIN tab, click on GET. Your phone IMEI number and model should be displayed on the bottom panel as shown below

5. Now click on the SERVICE tab and click on GET button under USER CODE

6. Your security code should now be dispalyed on the right side of the application waindow

download ant here

Check if usb ports are enabled from BIOS. To enter BIOS set press F2(it may be something else depending on mother board).>>>


Reinstall USB drivers with device manager. If u uninstall all usb ports and then restart windows surely install it again automatically for u.>>>


Still not working call expert to repair.


For ant other assitance [email protected]

when you plug a device in you might have start the add new device wizard click start control panel you should see add a new device or add hardware this may vary depending on the operating system you have also you might need to update install its drivers

you might need to update the driver or reinstall it
if you are having trouble with your drivers
here is a general look at the drivers and how to update them
if your computer came with a motherboard disc the drivers could be on it
click start control panel administrive tools ,computer management ,device manager look through all of your devices if you see a yellow question mark?or exclamation mark ! or red x
right click to reinstall drivers or
if you can see your usb but its not working
ports(com&lpt)right click update driver hope this helps

in the device manager click on (ports lpt com) double click on belkin usb adapter the properties will open then click advanced ant set the com port. you will find the driver here https://www2.belkin.com/support/product/?lid=en&pid=F5U109&scid=1

Go to intel and download and install this chipset deriver 845PE
It should fix your problem.

You need to go to the manufacturers website and download the drivers for your product.

Es un computador de casa o un laptop? Si es de casa entonces deves de instalar el USB Adapter en la connecion mas alta para poder agarar el signal mas potente. No importa si es adelante o atras

Antes de instalar el USB adapter devs de instalar los Drivers del USB adapter antes.

Remove the camera software entirely. Assuming you PC is 2000/XP no camera software or driver is required. It should simply come up as a new drive in My Computer Come back on this one