20 Most Recent Progressive Dynamics Inteli-Power PD4560K18L Series Power Management System Questions & Answers

Tip

How to repair Motorolla Talkabout 250 antenna


I have just repaired four of these radios, with complete success.

You need a tube of black Stixall (currently £5.81 from Tool Station), a skeleton gun and a saucer of water with a good squirt of washing up liquid.

Take the back off the radio, take out the batteries and remove the rear cover by undoing the retaining screws using a screwdriver with a star shaped bit. Unscrew the circuit board now exposed using the same screwdriver bit. Remove the damaged rubber aerial with coiled copper core, being careful not to damage or distort the copper core. It lifts off one of the screw lugs revealed when removing the circuit board. Get rid of all of the old rubber.

Now put the end of the copper coil back over the lug (where it came from) and screw the PCB back on followed by the back of the unit.

Now form a new rubber cover to the copper aerial using Stixall, squirted into place. Squirt it down into the aerial housing so that it will get mechanical purchase from the body of the radio. Put on plenty, completely coating the copper aerial. Now dip your fingers in the saucer so that they don't bond to the Stixall and mold it into a smooth aerial shape. Leave it to cure for 24 hrs and then dust it with flour. Job done.

I have tested my repaired radios and they are great, the new "aerials" have lasted well. I am especially pleased that I don't have to throw them away.

Good luck - regards SJP

on Oct 16, 2019 | Electronics - Others


Plenty here;
https://ksp-electronics.com/en/product/view/5741-ta1319ap

Electronics -... | Answered on Oct 15, 2019


Error. Over Current - Peak current exceeded
Possible causes:
Motor has a short - Phase to phase or phase to ground.
Motor cable damaged/defective.
Motor cables too long.
Acceleration/deceleration ramps too short.
Damaged output phase of inverter.
EMI

Electronics -... | Answered on Oct 14, 2019


Three years is pushing the life of the batteries. Have them checked where your type of battery is sold.

Electronics -... | Answered on Oct 13, 2019


You can use Card Data Recovery. It is the professional SD card data recovery software. It can recover photos, video, audio and documents from SD card, miniSD card, micro SD card, etc. This program has two versions, one for Windows users, one for Mac users. You can visit its official website to have a look.
Card Data Recovery for Windows
Card Data Recovery for Mac

Electronics -... | Answered on Oct 11, 2019


it means you can't write new files or alter the files.
It is cs26466 ?
this has a password protection feature apparently
is it an sd card ? move the tab on the side of it
If it is a usb flash drive I do not know how you get pass the passwor dor how you enter a password when accessing it ?

Electronics -... | Answered on Sep 20, 2019


Write protect in flashdrive could mean chip problem if you cannot partition or reformat the usb drive..you can try usb low level format, partition application..be sure to back up files before doing so.

Electronics -... | Answered on Sep 19, 2019


Connect and get best solution of email related issues. Webmailhelps

Electronics -... | Answered on Aug 30, 2019


When Ally starts chanting "I need my pack", it can become your worst nightmare. I can't find "the pack" but I'm guessing it's the keypad that you plug into her wrist. My bet is the pin/plug connectors in these dolls were not super awesome quality wise and sometimes didn't register they were connected (the program cards were a bit glitchy as well). Once the batteries need replacing, the doll needs to be reprogrammed hence the keypad connection request. Just a guess...

Electronics -... | Answered on Jul 26, 2019


I don't know how new these are, but there is one trick to try to recover a battery. Make sure it discharges completely(will not turn on at all, no matter how hard you try). Then charge it completely. Continue to discharge and recharge, (again, when discharging try again and again to turn it on till it will not come on at all).
This process should start to help the battery get back it's charging 'memory' and you should notice the battery last longer and longer with each charge. If this does not work, there is a problem with the battery. Good luck!

Electronics -... | Answered on Jul 14, 2019


It should have a small 120V to DC wall adapter charger with a DC wire / connector jack that plugs into the back of the power pack. Plug the wall adapter into 120V outlet and plug the DC connector jack into the back of the Power Pack. Leave on charge until the unit indicates it is charged fully (several Hours if it was fully discharged).

Electronics -... | Answered on Jul 14, 2019

Tip

2004 Honda Pilot Left Hand Window Controls.


Just sharing that if you change out the controller arm for the window raise and lower, and you are trying a test run of the new control arm before installation,

YOU WILL NEDD TO MAKE SURE THAT ALL, ELECTRICAL CONNECTIONS ARE HOOKED BACK UP. INCLUDING THE DOOR SAFETY PANEL LIGHT.
( No need for the speaker connection at this point).

If if you have one electrical plug not plugged back into where it came from, you will not get any action from the window motor control arm AT ALL !!!!!!

Hope this helps someone soon. Thanks goes to another user of this sight of open knowledge as he had mentioned it in a reply that I was able to read and add to I hope.

on Jul 06, 2019 | Electronics - Others


These are all messages that follow overheating. E.nOH indicates that the heat sink has returned to the normal temperature range and the unit can be reset. E. OH indicates that the power module is over-temperature. This could be caused by insufficient air flow at the heat sink. That is caused by dust/dirt. The ventilator could be clogged or the ambient temperature is too high. E. OH2 indicates that the motor protection relay was tripped. Check for dust/dirt and clean any filters. Make sure that nothing is blocking the air flow around the unit.

KEB uses these error mesages on the CombiVert F6, https://www.keb.de/fileadmin/media/Manuals/f5/control/f5m/00f5mebk320.pdf .

I hope this helps.

Cindy Wells

Electronics -... | Answered on Jun 01, 2019

Not finding what you are looking for?
Progressive Dynamics Inteli-Power PD4560K18L Series Power Management System Logo

0 questions posted

Ask a Question

Usually answered in minutes!

Top Progressive Dynamics Electronics - Others Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Brad Brown

Level 3 Expert

18108 Answers

Tom Chichester

Level 3 Expert

54195 Answers

Are you a Progressive Dynamics Electronics - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Progressive Dynamics Electronics - Others

  • Progressive Dynamics Electronics - Others

Most Popular Question

compressor turn off motomaster

  • Electronics - Others
Loading...