20 Most Recent
Whirlpool 10 cu. ft. / 283 liter Chest Freezer EH100FXKQ - Page 9 Questions & Answers
Tripping electricity
HI, The reason for the over-pull is due to the unstable conditions located at the main PCB that controls this affected unit. The voltage is not stable, due to the damage located at the PCB(circuit instabilities). Just to be safe, have your local electrician inspect the breaker box for shorts and damage to the appropriate circuit block. If the electrician confirms that the breaker is in good condition; replace the main control board(PCB) that is mounted near the compressor or behind the rear access panel.
7/21/2010 11:25:36 PM •
Whirlpool...
•
Answered
on Jul 21, 2010
Alarm on freezer keeps gooing off
low on gas or defrost mode failure....if the element become frozen then the air will not circulate around freezer compartment properly....check the defrost element or timer.
7/20/2010 7:16:19 PM •
Whirlpool...
•
Answered
on Jul 20, 2010
The tube feeding the ice making machine is iced
The water inlet valve on the back of unit opens when the ice maker needs water. If the valve doesn't seal good because of sediment or wear it will continue to drip and when the water reaches the ice maker supply tube it will freeze blocking the fill tube.. You can take the water line off the valve and watch to see if it drips.
6/4/2010 2:21:19 PM •
Whirlpool...
•
Answered
on Jun 04, 2010
Not finding what you are looking for?