Top 20
Avanti DER24CW-1 Electric Kitchen Range Questions & Answers
Oven not heating up
1. Check the incoming voltage to the unit. There should be 240 volts with a neutral.
2. Check power at the Dbl (double line relay) from (Com) to neutral. There should be 120 volts
incoming to the Dbl. Refer to picture for testpoints. If voltage is ok, move to step 3.
3. Program the unit into a bake cycle. Check voltage across Dbl (double line relay) (N.O. side)
to BA relay for 240 volts. If no voltage replace relay board. If you have 240 volts go to step 4.
4. Check the HTC (high temp cutout) or thermal fuse for open circuit.
The thermal fuse is located on the rear of the oven - behind the back panel. While there, you should find a service manual for the oven with locations and troubleshooting info.
The element may have also failed - you can deduct this if all the previous checks are good and there is voltage at the element.
To test the element - Remove it from the oven, and Using your ohmmeter, set the range scale on R x 1 and place the probes on the element
terminals. There should be continuity, with readings ranging from 19 to
115ohms.
Readings will vary from manufacturer to manufacturer and according to
unit size and the wattage. Be sure to check your manual for the
manufacturer's specifications.
If there is no continuity - the element needs to be replaced.
So - in summary - there are a multitude of items that COULD be wrong...
1. High Temp Switch Failure
2. Thermostat Failure
3. Element Failure
4. Control Board Failure
If you have further clarifications - please use the "Continue with this expert" option so we are connected in the future.
Thanks for using FixYa! :D
Stove top gas spark ignitor
The gap between the burner and the spark tip may be obstructed. When I clean mine none of them work until they all dry completely.
Avanti G2002CW oven or broiler won't stay lit once ignited
I had this same issue on this same model (which is how I happened upon this page). I'm still not exactly sure why, but the problem resolved when I pushed down on the knob more firmly than I normally would to light the stove, and it seemed to slide in a little deeper. After that, the oven would light.
I can find a model #
Look inside the bottom drawer on the frame, if not there look on the sides of the drawer or on the sides of the oven door.
We have an avanti small
If the breaker on a 220 line looks does not mean that it is. I recommend tripping the breakers and resetting them because one leg of the 220 can trip but the other leg can keep it in the nontriped position. Reset breaker just to be safe. There is no reset on the stove. You can check the plug to make sure that you have 220 to it also with a meter. Plugs do not go bad though.
The oven temperature of my
These models all have a 'calibrate' function built into the menu. You will have to refer to the owners manual for step by step instructions. It's fairly simple to do. This function will allow you to bring the temp. of the oven up and then set it to the actual temperature it's at inside. You will need an oven type thermometer to observe inside the oven. Set it in on a rack and watch it, then go through the calibrate steps.
If you need further help, I’m available over the phone at
https://www.6ya.com/expert/craig_3fa289bf857b1a3c
Not finding what you are looking for?
