Question about Honda CBR 600 F(4)i Motorcycles
...seat cowl on the left hand sise you will see the cdi unit (black box with wires going to it) you should see a black conector with two wires going to it bridge the wires with a pice of wire or split ...
...seat to split seat can i change my single seat to a split seat conversion on my 99 honda cbr f4. using the split seat from a 200 f4i Yes check craiglsit or ebay you need to purchase the seats the ...
...split seat, I believe the lock for the seat is on the left side just under the passanger seat. Insert key and turn it to un-lock. While holding the key in the un-lock position, lift up the drivers ...
Question about Honda CBR 600 F(4)i Motorcycles
...hold down bolts located on the rear fender for the split seat model, if your seat is not split, just removing the 1 bolt located in the compartment will fix your problem...Good luck & ride
remove seat from 1996 FLST N Just wish to get at the battery, and am having difficulty removing the rear portion of the split seat. is it bolted through the rear mudguard ??
...split float or even a worn needle or float needle seat oring .get the carbs out and have a look at them. Undo the airbox push it backwards undo all the inlet clamps and Airbus clamps and wiggle the ...
Question about Motorcycles
...seat on my Yamaha XJR 1300 SP. A mechanic did it in a split second in the garage, but I wasn't paying attention... Robert SeatTo remove the seat1. Insert the key into the seat lock,and then turn ...
Question about Honda CBR 600 F(4)i Motorcycles
...split in half, there is a needle and seat in each chamber and I would say that you likely have something caught in the needle and seats. I attached a diaphragm. One problem Float needle ...
Question about Honda CBR 600 F(4)i Motorcycles
seat from the frame and remove it from the bike. 2 Don a face shield and rubber gloves. 3 Remove the battery cover retaining screw from the bottom of the battery cover using a ratchet and Allen driver
...seat must be clean and have no debris on it. The float valve must be clean and show no damage. The slightest scratch, split or dink to the float valve will prevent it working properly. All ...
85 questions posted
Usually answered in minutes!
20 Questions
24 Questions
12 Questions