Dewalt D51256K 16 gauge finish nailer kit "nail gun trigger valve" Questions

...nail gun Remove the nails and take off the trigger to expose the trigger valve (usually part # tva6). Connect air and spray soapy water on the valve to determine if the air is leaking from the center ...

...nail gun. It is leaking from the trigger and it is trying to fire a nail and discharges the rod to drive the nails and the rod stops and will not retract. I think I need to purchase an O ring kit Ork ...

...gun. With pins removed and trigger out, nails removed and with a gloved hand, apply air pressure to gun to pop out the valve. Use caution because the valve will come out with force if air pressure is ...

...trigger valve on the body of the gun, notice one or two roll pins that you need to punch out using a 3mm punch. With roll pins removed the valve can be pushed out with air pressure. With gloved hand ...

nail gun o-ring for the nail gun triger. air is leaking from the triger the trigger assembly would need replaced. I have detailed instructions in the tip section on the removal and installation of the

...trigger valve on the body of the gun, notice one or two roll pins that you need to punch out using a 3mm punch.  With roll pins removed the valve can be pushed out with air pressure. With ...

nail gun shoots 2-3 nails, not one. last week 2 of them hit me in the thumb. has been doing this for years. I have put up with it because I did not know what to do about it. Most nailers work better ...

...gun does not fire, make sure that the safety foot is depressing the trigger valve all the way in when attempting to nail. Simple test is to remove the trigger exposing the firing pin. With nails ...

...gun. It just started leaking at the Trigger while waiting to be used. Was working right along. The trigger valve has about five orings and will usually begin to leak before it fails. Replace ...

Help with Bostitch N60 air nail gun. Bostitch n60 nail gun leakes air at trigger. If it is a N60FN you will have to install a new trigger valve P/N TVA6. Any Bostitch service center should have them.