...water, and that is all it will do. It will set like that until I disconnect the thermostat wire and plug it back in. Then it will continue the cycle as normal. Is my thermostat bad and if so is it a ...
...water not hot could be a number of problems. Checking with an ohm meter would determine the problem. Could be the booster high limit thermostat, a burnt wire, booster thermostat, or a heater ...
water being circulated during wash cycle. If so the heater, control board, thermostats or wiring are most likely bad. If heater, therms, and wiring check good its usually the control. When fixed press
...water cut-off board. Also there is the transformer to check. The only way to test the thermostats without a meter is to jumper a wire across the terminals. This has some real personal dangers. Turn ...
...heater does not come on. Is there other safety features I am missing see the w .diagram 1) the water must be preheating by heating elements and thermostat if this device fails, the machine will not ...
...water does not heat when the dishwasher is being used on any programme. I've tested the heating element (at least I think I have) which gave a reading of 26 Ohms. What could be the problem? Please ...
...water Hello Open the door and take out the baskets and have a good look at the heater in there. See if theres any signs of it blown. If not then you need to check the heater out with a multimeter. ...
...water heater element. I can see that people have asked for some help with getting access to the unit. any chance of a 'heads up' on that one too. I've checked the circuitry and there doesn't seem to ...
Question about Candy Dishwashers
...water pump, the heater, the thermostats and when is on, immediatelly heater is on. E3 - Water heating time out or fault The dishwasher has failed to heat with water in a reasonable time or has failed ...
1 questions posted
Usually answered in minutes!
10 Questions