...DLC Error Code Crankshaft Position System Variation Not... code p0315 refers to crankshaft position sensor--variation not learned====causes--engine mechanical fault--wiring have this checked out at a ...
...position outside the vehicle. The DLC is rectangular in design, capable of accommodating up to 16 terminals and has keying features to allow for easy connection. The DCL and Scan Tool connector have ...
...DLC Error Code Throttle Pedal Position Sensor Switch... HERE'S ANOTHER LINK ON TESTING IT, Repair Guides Components Systems Throttle Position Sensor AutoZone com HERE'S A LINK TO THE PART. Throttle ...
...DLC? The connector is not in my Haynes Repair Manual diagrams. My code reader can't link and my multimeter says there is no voltage present with the key in any position. Check the CIG fuse it goes ...
...DLC (OBDII) 16 pin connector located near the driver side kick panel. Turn the ignition to the ON position, DO NOT START. The CHECK TRANS light on the dash will flash any stored trouble codes. ...
Question about Kia Cars & Trucks
second, this means the remote was accepted to memory. 4. Turn ignition switch to the OFF position. Remove jumper wire from DLC. 5. Programming is now complete. Test remote to ensure proper programming
Question about Buick Cars & Trucks
position Locate the "Data Link Connector" (DLC), usually found near the driver's side kick panel or under the steering column. Connect a jumper wire to the DLC terminals A and B (consult the vehicle's
...DLC.SWITCH IGNITION SWITCH ON AND BACK OFF POSITION ENSURE DOORS LOCK AND UNLOCK INDICATING PROGRAMMING MODE ACTIVE.PRESS ANY BUTTON OF EACH REMOTE TRANSMITTER THREE TIMES WITHIN TEN SECONDS. WAIT 1 ...
DLC again driver window rolled down steering wheel in the straight ahead position. do not shake the vehicle you must be on a true level ground. No heavy load in the vehicle and no entering the vehicle
1990 Ford F250-Code reader won't fit test plugs. Can't find a code reader that fits. Any info on which terminal is which, so I can use a multimeter? Using an Analog Volt/Ohm Meter (VOM) Turn the ...
296 questions posted
Usually answered in minutes!
447 Questions
308 Questions
347 Questions
251 Questions
226 Questions