2001 Chrysler Town & Country "replace output" Questions

...Output Speed Sensor as the Speedometer Info is directly involved with this. If cleaning does not fix the problem then replace it and check operations, before replacing the Input Speed Sensor. This ...

...output shaft and replace the oil seal from the outside? Once done, I presume that I re-insert the output shaft and tighten the nut inside the cone, but what is the torque setting for it? Any thing ...

replace the output speed sensor..located on front of transmission..near driver's side wheel..2 pin connector..unscrews from transmission case..fairly inexpensive part..around 35-40 bucks These are the

...replace the solenoid pack you should at least check the output speed sensor. If this sensor fails it will also set a code and put the transmission in limp mode. You will need a high end scan tool to ...

...engine If you have changed your output seal and are still losing fluid by it, you probably need to replaced the rear bushing also. And check your driveshaft yoke for excessive

...output, replace the switch. If you find an output, check the wiring all the way back to the reversing lamps with the test lamp by carefully stabbing the correct wire until the test lamp no longer ...

...diagram of how the turn signal and flasher work to be able to trace my problem The flasher must be replaced by the full unit and best not to repair. there is no need of a diagram as the positive ...

replace rear end output shaft seals (inner axel seals) 98 town and country? What fluid goes back in? I assume you mean trans axle seals in front. You have to remove the drive axles,best done on a lift

I have alternator problems replaced alternator still no chaqrge. I have been told the computer controls alternator output. but the computer can be bypassed since cannot find a computer replacement. ...

output voltage should be 4-5 volts. The voltage should fall to 1.5-2.1 volts with a hot, neutral idle speed condition. If OK, go to the next step. If not OK, go to Step 5. Test the PCM terminal 36 for