2003 Mercury Mountaineer "removing starter 4 wheel drive" Questions

...starter cable in place, remove the cable and position it out of the way. 4. Disconnect the solenoid connector...the smaller of the two wires going to the starter. 5. Remove the bolts holding the ...

starter to the engine. On the V6 there are 2 bolts, top and bottom. On the 4 cly there can be 3 of them, top bottom and out to the side. 4. Here you have to make a judgement call depending on the type

starter wiring. 4.3L Engine 2 wheel drive just remove the right front tire and you will have access to the wiring. 4.3L Engine 4 wheel drive you must remove the differential carrier shield if equipped

4, remove the two bolts that hold the starter to the engine. 5 pull starter straight out. ----- now just follow in reverse for install and you are done. and yell at your hushand to get YOU the beer --

...4 wheel drive high, would i hear a noise like a whinning or a clicking from somewhere? wheel bearing my 2002 explorer engages into low range by it self and i cant it to diengage but i made a big bang ...

...Starter-to-engine block bolts. When removing the last bolt, be sure to support the starter to keep it from falling and possibly injuring you. Starter and shims (if equipped) from the vehicle Bracket ...

...starter from a 4 wheel drive ford explorer sport? Disconnect the negative battery cable ,Jack up the vehicle then crawl under the vehicle .Locate the starter , disconnect the wires attached to the ...

...4" drive socket and rachet. Remove the two starter wires from the starter. Remove the ground cable nut. Move the cables out of your way and remove the bolts holding the srter to bell housing. Starter ...

...starter on a 1999 Chevy S10 4 cylinder? Hi, Start by disconnecting the negative battery cable. I don't know if your vehicle is 2 wheel or 4 wheel drive, but please note that on some 4WD vehicles, ...

...4. Remove the wire(s). One is a big cable, like a battery cable, bolted to a stud on the side of the starter. 5. Remove the bolts that connect to the starter to the transmission (bellhousing), at the ...