2000 Chrysler Cirrus "remove brake booster dodge" Questions

Ad

Remove the IAC. To Install: Install the IAC to the throttle body. Tighten mounting screws to 5.1 Nm (45 inch lbs.) torque. Attach electrical connector to the IAC. Connect the negative battery cable. I

Ad

remove the brake master cylinder, do not remove any brake lines, there will be a vacuum line going into the booster, either from the front or the side, it's easy to spot, it's fairly large compared to

Ad

...brake booster check vacuum leak first. if this is not present remove actuator rod under dash @ booster. remove master cylinder and lines. Remove bolts around outsid edge of booster along with all ...

...in the vacuum brake booster will.  Remove the master cylinder and look for brake fluid in the booster assembly.  If there is fluid in there, replac both the master cylinder and the

...remove the brake mastercylinder pipes i.e. to get access to remove the brake booster, you may before tht judge if theres enough space to just remove the complete brakemaster cylinder from the booster ...

...idling should the truck rev up as I’m pumping them Sounds like brake booster is bad.check for vacuum leak.remove vacuum hose and cap off then start engine. should idle fine if so change brake

Question about Chrysler Cirrus

1 Answer

brake booster. Power boosters don't have fluid in them. This sounds more like your master cylinder is leaking out the back were it joins the booster. Replace the master cylinder, and while you have it

...brake pedal,it is held in place with a push pin and hair pin clip,remove the clip and then the pin,now you can remove the push rod that was connected to the pedal,Now look at the fire wall where you ...

the hood. Add DOT3 brake fluid as specified by the manufacturer, after removing the cap or lid to the master cylinder which has a direct link through the booster to the brake pedal behind the firewall

Question about Chrysler Cirrus

1 Answer

pedal arm under dash inside of trk their should be 2 nuts or 4 buts under dash on inside of firewall near brake pedal then remove booster pulls out from under hood. there is not much to replacing them

Not finding what you are looking for?
2000 Chrysler Cirrus Logo

611 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...