...5-23-30Generator to Bracket Bolt3727-Generator to Cylinder Head Bolt4835-Generator Brace to Upper Intake Manifold Bolts and Nut12-209-14-Intake Manifold Support to Throttle Body8-12-71-106Intake ...
...5: Rotate each bolt an additional 90 degrees. intake bolts are: Install the intake manifold. Tighten the bolts in the sequence shown in two stages. Stage 1: Tighten to 15 Nm (11 lb-ft). Stage 2: ...
...5 things going on.. First check for vacuum leaks. You may hear a hissing. If you hear nothing , then check the air intake manifold gasket. This is where the air intake manifold bolts onto the motor. ...
...(2 Req'd) 8 A4670 Vacuum Tube Assembly 9 9424 Intake Manifold 10 9J459 EGR Vacuum Regulator Solenoid A - Tighten to 5-7 Nm (45-61 Lb-In) Hope this helps broken window regulators on buick
...intake manifold. Loosen the hose clamp and pull the radiator hose off the water connection on the thermostat housing. 3 Take out the two bolts on the thermostat housing cover with a 13mm socket or ...
...Intake Manifold 4 N602704-S Screw and Washer 5 12126 Camshaft Position Sensor 6 12A362 Synchronizer Assembly 7 12270 Hold-Down Clamp A ? Tighten to 1.5-4 Nm (13-35 Lb-In) B ? Tighten to 19-30 Nm ...
...intake manifold gaskets, exhaust manifold gaskets, thermostat, flush and fill (though not a back flush), and all other related gaskets. I have recently been driving the car around town with no ...
...5 times? P171 and 174 is running lean that means you have either no fuel pressure, bad fuel pump, cloged fuel filter and somethimes vacum leak on your intake manifold gasket. 443 indicates EGR valve ...
Question about Ford Taurus
INTAKE MANIFOLD SIDE (6) (4) (2) (8) (5) (1) (3) (7) EXHAUST MANIFOLD SIDE Start with 1 then 2 and so on. . Tighten the bolts to 47 ft. lbs Then back all the off 1 full turn. then in the same order re
1,440 questions posted
Usually answered in minutes!
2,348 Questions
2,262 Questions
2,121 Questions
1,869 Questions
1,431 Questions