1987 Volkswagen Jetta "adjustable driver seat" Questions

drivers seat adjustment seat keeps adjusting itself, i even noticed it doing it with no one in car-no keys in hand, ect Look below the seat and find the wire harness that leads to the seat switch. ...

...Driver's seat will not latch into place, just slides along track no matter how much one fiddles with the lever. the latches that lock into the fixed slide rails ?if you look under seat you will see ...

seat on drivers side of VW jetta will not lock into place. It is a manual type, not power. Check the adjuster lever, make sure it's returning all the way. Also, check the track under the seat for any ...

...driver's seat. Measure the distance from the floor to the center of each headlight. Mark these heights on the wall and draw a line between them. Measure the horizontal distance from the reference ...

...adjustable, it came apart. You have to fold down the back seat, remove the trunk lid liner and pull on on the plastic piece connected to the latch mechanism on the deck lid. It is a little difficult ...

Where is the clutch auto adjustment located at on a 98 manual Volkswagen jetta? you most likely have a hydraulic clutch, which the clutch master cylinder is located on the firewall on the driverside ...

...driver's seat of the Passat and close all the doors. 2Position the trip/odometer button to display the odometer mileage reading, then hold it down with the forefinger on your left hand. 3Turn the ...

...Driver seat lumbar support adjustment switch -E176-, Front passenger seat lumbar support adjustment switch -E177-, Driver seat lumbar support curvature adjustment motor -V125-, Front passenger seat ...

Driver door control module, Front passenger door control module Fuse 46 - 30A - Left rear door control module, Right rear door control module Fuse 47 - 15A - Fuel pump control module, Fuel pump relay,

driver seat module ! The seat adjuster motors are controlled by the driver seat module through the adjuster motor control circuits. In an inactive state both of the motor control circuits are grounded