...remove the wiper arms, then carefully remove the rubber seal and plastic scuttle panel trim.Some edges are sharp so be careful. Be careful not to loose any clips or rubber seals. You will see the ...
...Remove this bolt, lift the wiper arm away from the glass on its spring hinge and then pull the wiper assembly off the telescopic shaft. Some real effort may be required here, but it will come free ...
Question about Mercedes-Benz C-Class
...2002 SG350L? One of my wipers just stopped moving? Remove the wiper arms and lower windscreen cover. Check the wiper motor linkages first .These clips normally come loose.Refit or replace the ...
Question about Mercedes-Benz C-Class
...wipers and then switch off that is the park position now remove the wipers from the shaft and reposition to the park position on the screen refit the nut and they will stop in the park ...
Question about Mercedes-Benz Cars & Trucks
...refit it in the same place. Remove the rubber that goes around the bulkhead sealing off the engine bay. Then just carefully remove the screws and clips and lift off the scuttle panel. The rest if ...
off. The motor should continue for a second or two and then stop. Switch off the ignition. Position the wiper blades in the proper parked position and then refit the wiper linkage crank to the motor..
remove the nuts and arms. Take of the cover and locate the wiper motor. Refit the rotating arm, making sure to sync it for self parking and then fit back the rotating arm of the wipers. If the nut has
Question about Mercedes-Benz C-Class
...Remove the Bolt, Allow it to go to the SEATED position and then you will be good to go Make sure the wiper arms are fitted to the motor drive in the correct orientation. The motor will only go in one ...
...wipers crossed over and quit working Remove the wiper arms from the system and check if mecanism is worling then refit at correct positions. If not check fuse then motor then switch and
...remove the small snap ring and washer followed by a rubber sealing ring. i used a vice to push the spindle from the linkage, clean it up and regrease it with lots of bearing grease refit and jobs a ...
509 questions posted
Usually answered in minutes!
630 Questions
615 Questions
474 Questions
420 Questions
413 Questions