1996 Buick Century "replaced evap purge solenoid check" Questions

Question about Buick Century

Emission control malfuction

EVAP purge solenoid and EVAP vent solenoid are turned on. This allows engine vacuum to draw a small vacuum on entire EVAP system. Whenever a sufficient vacuum level cannot be achieved, a large leak or

Question about Buick Century

1 Answer

Whats code p1441

...EVAP purge lines.The evaporative emission canister.The EVAP purge valve.The Powertrain Control Module (PCM) supplies a ground to energize the valve (purge ON). The EVAP purge valve control is Pulse ...

Question about Buick Century

1 Answer

I am getting P0440 EVAP

...or disconnected hoses around the Evap purge solenoid Check and/or replace the sensor Check and/or replace the purge valve Have a professional use a smoke machine to detect leaks Keep us

Question about Buick Century

3 Answers

Error code 0440 on a 2002 buick custom

...Evap purge solenoid Check and/or replace the sensor Check and/or replace the purge valve Have a professional use a smoke machine to detect leak p0440 is an EVAP system leak. A large one. If you left ...

Question about Buick Century

2 Answers

Location of sensor for troubleshooting po442 to

...vapor line (2) Fig. EVAP canister purge solenoid location on 3.1L & 3.4L Fig. EVAP purge solenoid valve (3) location on 3.5L Hope this help, good luck. code 442 is small evap leak, check gas

Question about Buick Century

1 Answer

P1665 code

...EVAP Purge Solenoid and/or its wiring malfunctions, the solenoid (and possibly its wiring) might have to be replaced. However, a loose-fitting or worn gas cap could also be the culprit, and it's easy ...

Question about Buick Century

1 Answer

I have a 1996 Buick Century...Having codes P1651, 1652, and 1655 come up...can clear the codes and will drive for about 4 days...then either have to clear codes again OR have to figure out where these

...OUT? fan 1 and 2 relay, and the 1655 is evap purge solenoid, the fan relays going bad can cause the car to run hot or overheat, check for broken vacuum lines and replace the purge solenoid if

Question about Buick Century

1 Answer

96 Buick Century won't pass imisions code P1441

evap system flow during non-purge check the hoses for holes or broken disconnected hoses also check the fuel cap emissions diagram under the hood will give u the location of the evep purge solenoid if

Question about Buick Century

1 Answer

1996 Buick Century 3.1L V6 P1441 EVAP Problems.

EVAP Problems. I have a 1996 Buick century 3.1L V6 that has recently had the head and manifold gaskets replaced. About a month later the car began to shake and sputter a lot in drive. I noticed it did

Question about Buick Cars & Trucks

1 Answer

I got 97 buick century custom 3.1 that had a p1441 code for evap purge solenoid so i got a new one now its throwing p1655 evap purge solenoid circuit

replaced, the new PCM must be programmed. Refer to Powertrain Control Module Replacement/Programming . DTC P1654 -- EVAP Purge Solenoid Control Circuit Step Action Value(s) Yes No 1 Was the Powertrain