1998 BMW 5 Series "replace stop light switch 98" Questions

...stop working for another day or two. The same for the dashboard lights and occasionally the emergency flasher will have the same experience. Today the repair shop replaced the ignition switch and the ...

light switch , this unit is all electronic inside and it sounds like the hazzard light unit has failed , You might find you can solder a connection on the back but i cannot remember what model or make

...lights do not work the bulbs have been replace and so has the fuse, any ideas? replace the transmission park and neutral switch.most of the time when it stop working your back up lights stop

...engine servised soon light came on the next day. Replaced blower motor resistor and no help, fuses good. help!!! check if you can slowly turn the key, if they start working, replace the ignition ...

...if brake lights turn on. if brake light illum,there you go replace switch. make sure pay special attn how switch comes off after pulling pin out. also try fuse if all else is ok. 2006 f 150 stop ...

...Stop light switch replaced Rest of the tail lights work fine What else could B? have you tried to find the brake pedal switch? follow the brake pedal under the dash and there should be a switch that ...

...switch, and the brake light from the brake pedal switch for stop run through the multi function switch,your solution is the mult function switch, also just to be sure make sure your hazard are not

stop leak 10011 Read Reviews on Lucas Oil 10011 There is a lot to diagnose and check,, MORE than can be done on here... Has the vehicle ever been wrecked in the back?? Make sure the tail light sockets

...stop light switch, replaced the 15amp fuse, disconnected each light one at a time and still not working. Check the ground to the brake light socket. I had a similar problem on a 98 626 and found the ...

...and turn signals on the same circuit? Would a flasher failure cause a problem with brake light function? A flasher would not cause this problem, It's in the trun signal switch, it needs to be ...