1994 BMW 3 Series "318i pull" Questions

...318i - ignition lock cylinder removeal turn key to 1st position insert a 1.2 mm rod (blunt end of a drill bit) down the hole at the side of the lock barrel puch detent in and pull barrel out with

what does the switch for the gear box do on a 1994 318i? allows you to pull away in 2nd gear (in snow to help stop wheel spin)

...318i wont start turns over no buzzing from fuel pump but induce power pump activates but still wont start the plug into the pump cud be corroded--pull and clean--chec fuses--pump may need ...

...318i engine small amount of oil on front of engine pull the ruber shroud /cover off the oil light switch ,i think the oil light switch is leaking a small amount and building up behind the cover ...

...318i 3 series year 1994 As I pull out quickly at a juntion I put it in first gear and disengage the clutch then apply full revs the car jerks and judders It has had new clutch fitted and only does it ...

...318I You should purchase a manual from the folks at Bavarian. It's not that expensive. I have the same model. There are a number of steps to get the top down. You need to make sure windows, key, etc. ...

...318i To check for a drain disconnect the negative at the battery, Connect a test light to the neg battery and the other end to the neg wire. If the light comes on some thing is pulling power.(make ...

...318i e46 2000 model I cant seem to get pwer to exeed 130km/h. the car jerks when driving from cold, I must first leave it to idle to pull off smoothly. But still with very little power. someone ...

The electronic windows in my 1993 BMW 318i do not work. Why? It is a four door sedan, and my son purchased it. Also, he was checking the fuses and now the sunroof is not working. Is there a probable ...

...318i M reg 95? Sometimes tasks like this seem bigger than they are, my first suggestion is go to the part store and look at the part, have them pull it out and let you hold it, and will let you see ...