2000 GMC Sierra "5 bad" Questions

5 o clock position any idea s Bad IPC.......If u can round up a tech 2 scanner, do a guage sweep and i bet u will see the temp guage will not operate correctly......a new IPC (Instrument Panel Cluster

heater blower only works on one speed. has 5 settings 123 dont work 5 dont work blower motor resistor bad.it is under the dash on the passenger side.

...bad. The highest setting 5 has no resistor, so the blower runs on high but the high current flow ends up burning up the switch's contact on that setting or the resistor wire harness at the blower ...

...5 how do i fix this you talking about the fan speed? if so the fan resistor module could be bad or on the gmc the plag on the module likes to melt a litlle loosing contact at the plug in check that ...

...be the cap is no longer maintaining the correct pressure (you'll need to either test or just buy a new cap for $5-10) Worse case is the sensor for the fuel has gone bad (sensor is located in the

...the inline fuel filter it worked like for 5 miles it ran good.then it started again.Could it be bad gas or fuel pump? Check your fuel filter again. Dirt from the tank could have clogged it

...bad bushing or bearing, replaced the distributor set at #1 cylinder compression stroke. bucks when you try to start but if you can start it runs fine. weak spark at #1 plug wire to a external spark ...

...20miles and lost engine power i could get 2000 rpm then park for ten min fired it up drove good for 5 miles then the same thing no engine light I would test the fuel pump. If you are around 10k miles ...

...5 speed stick, speedometer does not work. What could the problem be? there is no speedo cable. You probably have a bad vehicle speed sensor (VSS).It is located in the transmission ,at the rear left ...

my heater only runs on the number 5. i think my heater switch is going bad. How do you replace it? switches do go bad but rarely, i think your problem is the resister.