2008 Lexus Rx 350 "replace valve stem seals tire" Questions

...valve stem leaking ? What's the fix ? replacement is only solution. you better take it to tyre shop and get it replaced This particular valve stem is aluminum.It is sealed with a gasket on the ...

...replace the core of the stem that will re seal it. if it only has a standard valve stem then a tire shop should have replaced them with the set of tires, the only way to replace them is to remove the ...

...when started relived pressure from shrader valve now gas pours out when started Replace the shrader valve the rubber seal on it is broken or cracked. Its not hard to change its like a tire valve

...valve stem problem.. I had the exact sme problem with my 300m chrome wheels.. It is NOT a tire problem.. it is a WHEEL problem.. The chome is very soft and begin to deteriorate from the inside.. Then ...

valve stem is actually part of the sensor - this is why you shouldn't have a charge for "Valve Stem" on your bill.) Installing the sensor with new seals, nut, and valve cap did not cause your light to

...valve stem, tread and sidewall area. do this slowly while looking for bubbles, sraying liberally. you might need more soap in the solution depending on the concentration of the dishwashing liquid. A ...

...Tire shops won't use a bead sealer unless you ask (Valve stems should have been replaced also). I for one always sand down corrosion on the rim bead, then apply bead sealer. Bead sealer is messy and ...

...valve stem leaking, tire to rim seal(corroded or damaged), even big changes in temperature can change air pressure in a tire. Best to take it into a good shop and have diagnosed and repaired. Check ...

...and you will be back to the same place soon. the most common auto air leak is a the valve stem, these can also be purchased and replaced, they are similar to a tire valve. I hope this helps, good ...

...replace my FPR on my 2004 Chevy Trailblazer. I am kind of a "newbie" so I need some help. Which size star key or hex key would be best? Will it be necessary to depressurize the fuel line, if so, how? ...