Question about Sears LiftMaster Building Materials
...light flashed 5 times, the repeats 5 flashes. billybob The code for that light flashing 5 times is 'motor overheated or RPM sensor failure'. The RPM sensor is a small printed circuit board just in ...
Question about Sears LiftMaster Building Materials
...dosnt help. Holding in the learn button didn't help. Suggestions? Sounds like you have more than one problem. The code for the light flashing 5 times is "RPM sensor or motor overload." ...
Question about Sears LiftMaster Building Materials
...light in opener blinks 5 times. When i reset the green light stays on until i try to operate opener then it goes back to 5 blinks. UNPLUG UNIT TO RESET. IF IT STILL FLASHES 5 TIMES AND MOVES 6-8 ...
Question about Sears LiftMaster Building Materials
5 times. Pushing openerer, I hear a click but no motor noise. Also, pressing the light button does not turn it on. When I pull plug, flashing light goes off until I press the open button and it starts
Question about Sears LiftMaster Building Materials
...light blinks 5 times I have a craftsman 1/2 hp that is about 2 years old. The learn light flashes 5 times and the door goes down about 5 inches and returns. No light bulbs flash(misalighned sensors) ...
...light on unit flashes 5 times. The code for 5 flashes is RPM sensor or motor overload. Did you remember to put the black plastic interrupter cup on the end of the motor shaft? Also check the small ...
Question about Sears LiftMaster Building Materials
...light flashes 5 times.. i've removed the chain, looked at the gears.. all looks just fine.. .no burned electric smell..what the heck ?? The code for the LED flashing 5 times is " Motor overheated or ...
Question about Sears LiftMaster Building Materials
light flashes 5 times, stops for a few seconds and flashes 5 times, continues... I reset power, codes, reverse sensors, etc. no change. Can it be the board? If so, looks like the cost is about $65.00.
Question about Sears LiftMaster Building Materials
...light next to the transmitter button flashes 5 times, pauses for three seconds, then repeats the 5-flash cycle. Any ideas? The gear needs to be changed kit #41c4220a. Be sure to change the bottom ...
Question about Sears LiftMaster Building Materials
...light does not flash then you can try increasing the down force just a little. This control is on the rear of the motor unit near where all those white wires go. Check the small LED near the ...
5,971 questions posted
Usually answered in minutes!
0 Questions