2001 Nissan Almera Tino "remove heater air control dash" Questions

Ad

Question about Nissan Almera

1 Answer

remove the entire dash assembly and replace the blend door. This door is located between the AC core and the heater core and "blends" the air from each (hot from heater core and cold from AC core

Ad

Question about Nissan Almera

1 Answer

...air box behind the dash ................ you may be able to pull the heater controls out of the dash and spot the problem but it's likely that the problem is in the air box itself and removal of the ...

Ad

Question about Nissan Almera

1 Answer

...control panel. Remove bezel with heater/air conditioning control panel .Remove the heater/air conditioning control panel from the bezel you will need this tool shown below to remove the factory ...

Question about Nissan Almera

1 Answer

...air box behind the dash ................ you may be able to pull the heater controls out of the dash and spot the problem but it's likely that the problem is in the air box itself and removal of the ...

...Remove the heater air plenum chamber assembly as outlined. Heater Air Plenum Chamber Removal Disconnect battery ground cable . Disconnect the heater water hoses from the heater core tubes. Plug the ...

Question about Nissan Almera

1 Answer

...Remove heater outlet floor duct (18C433) as described. Remove instrument panel (04320). Refer to Section 01-12 . Instrument Panel SPECIAL SERVICE TOOL(S) REQUIRED Description Tool Number Radio ...

Question about Nissan Almera

2 Answers

...remove all air in the cooling system until the heater is blowing hot air again. 4). You have a faulty heater core. I would suggest to do the easiest and cheapest fix 1st. Starting with a light tap on ...

Question about Nissan Almera

2 Answers

...remove the screws holding the case where the evaporator and the heater is We can get out and disassemble the box to get the heater no need to take the dash off un do the lines and take the 6-8 screws ...

remove the heater hoses from the heater core. Remove three heater stud retaining nuts and remove heater. Remove gasket between the heater hose ends and the dash panel at core tubes. Remove heater core

Remove the heater control knobs. Using a screwdriver, carefully pry off the heater control panel. Fig. Pull the finish panel and disconnect the wiring harness from the back Fig. Unscrew the instrument

Not finding what you are looking for?
2001 Nissan Almera Tino Logo

150 questions posted

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...