2010 Hyundai Santa Fe "remove back seat cover" Questions

Ad

...Remove the back panel of the seat, there are 5 or 6 plastic clips that hold the seat back cover on, start at the bottom of the seat back panel and work your way upwards, pull the panel downwards and ...

Ad

...remove your seat in the back of the car. The pump is under the drivers side rear back seat. You will have to remove the floor cover. You should see a panel. remove panel on floor and you will see the ...

Ad

Question about Hyundai Santa Fe

1 Answer

...back until they lock into place. 6. Reinstall rear covers by holding cover at a 45 degree angle and inserting the front tab into the rear of the roof rack. After aligning, snap cover in place (Figure ...

remove the 1-2 screws on the left side of the glove box and the right side of the glove box. The tray edges need to be pushed inward so the tray will flip open past the rubber stop slots allowing easy

...back and try it,we did discover some of the new filters sucking air. Good day. I had similar problem on my Terracan. I found that when it happens, the fuel level is just below the bottom end of the ...

...remove the back seat from my 1998 Mercury Villager it is not designed to be removed. It is designed to slide back and forth as needed. Section 01-10: Seats and Tracks 1998 Villager Workshop Manual ...

remove the back seats to add seat covers in a lexus ls400 1992 place a crowbar under the seats near the carpet and, pry up gently the car has clips under both sides of the center seats then: push down

...bottom cushion (refer to Photo 3). Reconnect the bib panel and pull down on the rear portion of the seat back cover to remove wrinkles. Spruce up Your Car: How to Install Seat Covers ' The Family

...to remove the seat back cover to evaluate the situation. Do any of you have any similar experience or advice? Thanks. SEAT RECOVERING How To Remove Seat Covers Lower Rear Seats Camaro Trans

Question about Hyundai Santa Fe

1 Answer

remove the cover. Do your patch/repair and put the cover back on. Before you start, get a box of hog-rings and a pair of hog-ring pliers to crimp them with back in the same holes you removed them from

Not finding what you are looking for?
2010 Hyundai Santa Fe Logo

184 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...